Accord L4-2.4L (2005)
Control Arm: Service and Repair
Rear Suspension
Upper Arm
Removal/Installation
Special Tools Required
Ball joint remover, 28 mm 07MAC-SL00200
1. Remove the clip (A) from the upper arm ball joint, and loosen the nut (B).
NOTE: During installation, install the new clip after tightening the nut a shown.
2. Disconnect the upper arm ball joint from the knuckle using the special tool.
3. Remove the brake hose mounting bracket (A). Do not disconnect the brake line.
4. Remove the wheel sensor harness mounting bracket (B).
5. Remove the flange bolt (A), and remove the upper arm (B).
Note: During installation, install the new flange bolt.