Accord L4-2.4L (2005)
NOTE:
^
Do not pull the driveshaft end outward. The inner driveshaft joint may come apart.
^
During installation, apply grease to the mating surface of the wheel bearing and driveshaft outboard joint.
17. Install the knuckle/hub in the reverse order of removal, and note these items:
^
Be careful not to damage the ball joint boot when installing the knuckle.
^
Tighten all mounting hardware to the specified torque values.
^
Before connecting the lower arm ball joint to the lower arm, degrease the threaded section and tapered portion of the ball joint pin, the lower
arm connecting hole, and the threaded section and mating surface of the castle nut.
^
First install all the components and lightly tighten the bolts and nuts, then raise the suspension to load it with the vehicle's weight before fully
tightening to the specified torque values. Do not place the jack against the ball joint pin of the knuckle.
^
Torque the castle nut to the lower torque specification, then tighten it only far enough to align the slot with the ball joint pin hole. Do not align
the castle nut by loosening it.
^
Install a new cotter pin on the castle nut after torquing.
^
Use a new spindle nut during reassembly.
^
Before installing the spindle nut, apply a small amount of engine oil to the seating surface of the nut. After tightening, use a drift to stake the
spindle nut shoulder against the driveshaft.
^
Before installing the brake disc, clean the mating surface of the front hub and on the inside of the brake disc.
^
Before installing the wheel, clean the mating surface of the brake disc and on the inside of the wheel.
^
Check the front wheel alignment, and adjust it if necessary.
Wheel Bearing Replacement
1. Separate the hub (A) from the knuckle (B) using the special tool and a hydraulic press. Hold the knuckle with the attachment (C) of the hydraulic
press or equivalent tool. Be careful not to deform the splash guard. Hold onto the hub to keep it from falling when pressed clear.
2. Press the wheel bearing inner race (A) off of the hub (B) using the special tool, a commercially available bearing separator (C), and a press.