Accord L4-2.4L (2005)
10. Remove the hub bearing unit (A).
11. Install the hub bearing unit in the reverse order of removal, and note these items:
^
Use a new spindle nut on reassembly.
^
Before installing the spindle nut, apply a small amount of engine oil to seating surface of the nut.
^
After tightening, use a drift to stake the spindle nut shoulder against the driveshaft.
^
Before installing the brake disc, clean the matching surfaces of the hub bearing unit and brake disc.
^
Before installing the wheel, clean the mating surfaces of the brake disc and the inside of the wheel.
^
Wash the spindle thoroughly in high flash point solvent before reassembly.
Hub Replacement-Drum Brake
1. Raise the rear of the vehicle, and support it with safety stands in the proper locations.
2. Remove the wheel nuts, and rear wheel.
3. Remove the hub cap (A).
4. Raise the stake (B), and remove the spindle nut (C).