Accord L4-2.4L (2005)
3. Remove the clip (A) from the upper arm ball joint, and loosen the nut (B).
NOTE: During installation, install the new clip after tightening the nut as shown.
4. Disconnect the upper arm ball joint from the knuckle using the special tool.
5. Remove the flange nut (A) while holding the joint pin (B) with a hex wrench (C), and disconnect the stabilizer link (D) from the stabilizer link
bracket (E).
6. Remove the damper lower mounting bolt (F) and disconnect the damper from the knuckle.
7. Remove the wheel sensor (A) from the knuckle. Do not disconnect the wheel sensor connector.
8. Remove the stabilizer link bracket (B) from the knuckle.