Accord L4-2.4L (2005)
5. Release the parking brake lever, and remove the brake drum (A). Screw two 8X1.25 mm bolts (B) into the drum to push it away from the hub.
Turn each bolt two turns at a time to prevent cocking the drum excessively.
6. Remove the hub bearing unit (A).
7. Install the hub bearing unit in the reverse order of removal, and note these items:
^
Wash the spindle thoroughly in high point solvent before reassembly.
^
Use a new spindle nut reassembly.
^
Before installing the spindle nut, apply a small amount of engine oil to the seating surface of the nut.
^
After tightening, use a drift to stake the spindle nut shoulder against the driveshaft.
^
Before installing the brake drum, clean the matching surfaces of the hub bearing unit and brake drum.
^
Before installing the wheel, clean the mating surfaces of the brake drum and the inside of the wheel.
Knuckle Replacement-Disc Brake
1. Remove the hub bearing unit.
2. Remove the splash guard (A).