Accord L4-2.4L (2005)
8. Wrap the splines on the driveshaft-with vinyl tape (A) to prevent damage to the boot.
9. Remove the inboard boot. Be careful not to damage the boot.
10. Remove the vinyl tape
Outboard Joint Side
1. Remove the boot bands (A). Lift up the three tabs (B) with a screwdriver. Be careful not to damage the boot and dynamic damper.
2. Slide the outboard boot (A) partially to the inboard joint side. Be careful not to damage the boot.
3. Wipe off the grease to expose the driveshaft and the outboard joint inner race.
4. Make a mark (A) on the driveshaft (B) at the same position of the outboard joint end (C).