Accord L4-2.4L (2005)
21. Bend the band end (A) by tapping it down with a hammer.
NOTE:
^
Make sure the band and clip do not interfere with anything on the vehicle and the band does not move.
^
Remove any grease remaining on the surrounding surfaces.
22. Repeat steps 14 through 21 for the band on the other end of the boot.
Outboard Joint Side
1. Wrap the splines with vinyl tape (A) to prevent damaging the outboard boot.
2. Install the new ear clamp bands (B) and outboard boot, then remove the vinyl tape. Be careful not to damage the outboard boot.
3. Install the new stop ring in the driveshaft groove (A).