Accord L4-2.4L (2005)
13. Apply a small amount of engine oil to the mating surface of the new spindle nut (A).
14. Install a new spindle nut, then tighten the nut. After tightening, use a drift to stake the spindle nut shoulder (B) against the driveshaft.
15. Clean the mating surfaces of the brake disc and the front wheel, then install the front wheel.
16. Turn the front wheel by hand, and make sure there is no interference between the driveshaft and surrounding parts.
17. Tighten the flange bolt and the self-locking nut with the vehicle's weight on the damper.
18. Refill the transmission with the recommended transmission fluid:
19. Lower the vehicle on a lift.
20. Check the front wheel alignment, and adjust it if necessary.
21. Test-drive the vehicle.