Accord L4-2.4L (2005)
10. Close the ear portion (A) of the band with commercially available boot band pliers (B).
11. Check the clearance between the closed ear portion of the band. If the clearance is not within the standard, close the ear portion of the band tighter.
12. Repeat steps 10 and 11 for the band on the other end of the boot.
Driveshaft Installation
Driveshaft Installation
NOTE: Before starting installation, make sure the mating surfaces of the joint and the splined section are not dusty or dirty.
1. Apply about 5 g (0.18 oz) moly 60 paste (PIN 08734-0001) to the contact area of the outboard joint and the front wheel bearing.
NOTE: The paste helps to prevent noise and vibration.
2. Install a new set ring onto the set ring groove of the driveshaft.