Accord L4-2.4L (2005)
19. Remove the shift solenoid harness connector.
20. Measure shift solenoid valves resistance between shift solenoid harness connector terminals below and body ground:
^
No. 1 (GRN): shift solenoid valve C
^
No. 2 (ORN): shift solenoid valve B
^
No. 3 (RED): shift solenoid valve E
^
No. 5 (BLU): shift solenoid valve A
^
No. 8 (YEL): shift solenoid valve D
Standard: 12 - 25 Ohms
21. If the resistance is out of standard, disconnect the shift solenoid valve connector, and measure its resistance at the solenoid valve terminal.
Replace the shift solenoid valve if the resistance is out of standard.
22. Connect the battery negative terminal to body ground, and connect the battery positive terminal to the shift solenoid valve terminal individually. A
clicking sound should be heard.
23. If no sound is heard, connect the battery positive terminal to the shift solenoid valve terminal, and check for a clicking sound. Replace the shift
solenoid valve if no clicking sound is heard.
24. Replace the shift solenoid harness if the test results are OK.
25. Install a new O-ring on the shift solenoid harness connector, and install the connector in the transmission housing.
26. Install the shift solenoid valve cover, dowel pins and a new gasket.
27. Install the new O-ring on the ATF dipstick guide pipe, and install the ATF dipstick guide pipe, then install the harness clamp on the ATF dipstick
guide pipe.
28. Secure the ATF cooler line brackets on the transmission hanger with the bolts.
29. Check the connector for rust, dirt, or oil, then connect the connector securely.
30. Install the transmission lower mount nuts.
31. Install the transmission upper mount bracket, bracket plate, and ground cable, then remove the transmission jack.
32. Refill the transmission with ATF.
33. Install the battery base, then install the air cleaner housing and intake air duct.
34. Install the battery tray, battery, and battery cover, then secure the battery with its hold-down bracket.
Connect the battery terminals.
35. Install the splash shield.
36. Enter the radio code (navigation code), reset the radio presets and set the clock.
37. Do the power window control unit reset procedure.