Accord V6-3.0L (2003)
Headliner: Procedures
Headliner Removal/Installation (V6)
Headliner Removal/Installation
SRS components are located in this area. Review the SRS component locations, and the precautions and procedures in the SRS section before
performing repairs or service.
With Side Curtain Airbag
NOTE:
-
When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
-
Take care not to bend and scratch the headliner.
-
Be careful not to damage the dashboard and other interior trim.
1. Remove these items:
-
A-pillar trim, both sides
-
Ceiling light
-
Front door sill trim and rear door sill trim, both sides, 4-door
-
B-pillar lower trim, both sides, 4-door
-
C-pillar trim, both sides, 2-door, 4-door
-
Front seat belt upper anchor, both sides, 2-door, 4-door
-
B-pillar upper trim, both sides, 2-door, 4-door
2. Release the tabs (A) on both sides with a flat-tip screwdriver, then remove the sunvisor cap (B) from the bracket (C). Turn the cap, and remove it.
3. Remove the sunvisor (A) and holder (B) from both sides.
-1 Remove the self-tapping ET screws.
-2 Remove the sunvisor from the body and holder.