honda Workshop Repair Guides

Honda Workshop Service and Repair Manuals

Sunroof / Moonroof Limit Switch|Locations > < Body - Moonroof Doesn't Close Completely
Page 2
background image

Skill Level:

Repair Technician

Out of warranty: 
Any repair performed after warranty expiration may be eligible for goodwill consideration by the District Parts and Service Manager or your Zone
Office. You must request consideration, and get a decision, before starting work.

REPAIR PROCEDURE

*1.

Remove the headliner. See page 20-103 of the 2003-04 Accord Service Manual. (In ISIS, use the keyword HEADLINE, and select Headliner
Removal/Installation from the list.) Use a trim pad remover to unfasten the headliner clips.*

2.

Mark the position of the moonroof limit switch.

3.

Unplug the 4P connector from the limit switch. Remove the two mounting bolts, then remove the switch.

4.

Install the new limit switch with the two mounting bolts, making sure the new switch is in the same position as the original switch. Torque the bolts
to 5 N.m (4 lb-ft). Plug in the 4P connector.

5.

Turn the ignition switch to ON (II), and check the operation of the moonroof with the moon roof switch (from the tilt-up position to fully closed;
from the fully open position to fully closed).

*

^

If the moonroof does not work properly, adjust the limit switch (see page 20-86). (In ISIS, use the keyword LIMIT, and select Moonroof Limit
Switch Adjustment from the list.) Reinstall the headliner.*

^

If the moonroof works properly, reinstall the headliner.

Disclaimer

Sunroof / Moonroof Limit Switch|Locations > < Body - Moonroof Doesn't Close Completely