Accord V6-3.0L (2003)
Seat Occupant Sensor: Service and Repair
Driver's Seat Position Sensor Replacement
Driver's Seat Position Sensor Replacement
Removal
NOTE:
-
Removal of the driver's seat position sensor must be performed according to the precautions/procedures described.
-
Before disconnecting the driver's seat position sensor 2P connector, disconnect the driver's airbag 4P connector.
-
Do not turn the ignition switch ON (II), and do not connect the battery cable while removing the driver's seat position sensor.
1. Make sure you have the anti-theft codes for the radio and the navigation system, then write down the frequencies for the radio preset buttons.
2. Disconnect the battery negative cable, and wait at least 3 minutes before beginning work.
3. Remove the driver's seat assembly.
4. Disconnect the floor wire harness or seat position sensor harness 2P connector (A) from the driver's seat position sensor.
5. Remove the Torx bolt (B) using a Torx T30 bit, then remove the driver's seat position sensor.
Installation
NOTE:
-
Be sure to install the harness wires so they are not pinched or interfering with other parts.
-
Do not turn the ignition switch ON (II), and do not connect the battery cable while installing the driver's seat position sensor.
-
After installing the driver's seat position sensor, make sure it is clean. Keep it away from dust.
1. Install the new driver's seat position sensor with a Torx bolt (A). then connect the floor wire harness or seat position sensor harness 2P connector
to the driver's seat position sensor (B).
2. Install the driver's seat assembly.
3. Reconnect the battery negative cable.
4. Check the operation of the driver's seat position sensor with the HDS.
5. Enter the anti-theft codes for the radio and navigation system, then enter the customer's radio station presets, and set the clock.
