Accord V6-3.0L (2003)
Control Arm: Service and Repair
Front Suspension
Upper Arm
Replacement
Special Tools Required
Ball joint remover, 28 mm 07MAC-SL00200
1. Remove the front damper.
2. Remove the wheel sensor bracket (A) from the upper arm (B).
3. Remove the cotter pin (A) from the upper arm ball joint, and loosen the nut (B).
NOTE: During installation, install the new cotter pin after tightening the nut, and bend its end as shown.
4. Disconnect the upper arm ball joint from the knuckle using the special tool.
5. Remove the upper arm mounting bolts (A), and remove the upper arm (B).
NOTE: During installation, install new upper arm mounting bolts.