Accord V6-3.0L (2003)
Shift Solenoid: Service and Repair
Shift Solenoid Valve A Replacement
Shift Solenoid Valve A Replacement
1. Get the audio and navigation anti-theft codes, and write down the audio presets.
2. Disconnect the negative cable from the battery, then disconnect the positive cable from the battery.
3. Remove the battery hold-down bracket, then remove the battery cover, battery, and battery tray.
4. Remove the intake air duct and air cleaner housing.
5. Loosen the two bolts securing the battery base from under the vehicle, and remove the two bolts securing the battery base in the engine
compartment, then remove the battery base.
6. Remove the starter.
7. Disconnect shift solenoid valve A connector, and remove shift solenoid valve A.
8. Install a new shift solenoid valve A with new O-rings (B). While installing the solenoid valve, do not allow dust or other foreign particles to enter
the transmission.
9. Check the connector for rust, dirt, or oil, then connect the connector.
10. Install the starter.
11. Install the battery base, then install the air cleaner housing and intake air duct.
12. Install the battery tray, battery, and battery cover, then secure the battery with its hold-down bracket.
13. Clean the battery posts and cable terminals with sandpaper, then assemble them and apply grease to prevent corrosion.
14. Enter the audio and navigation anti-theft codes, then enter the presets, and set the clock.
15. Do the power window control unit reset procedure.