Accord V6-3.0L Hybrid (2005)
7. Set the spark plug seals (A) on the spark plug tubes, and install the rear cylinder head cover (B).
8. Visually check the spark plug seals for damage.
9. Inspect the cover washers (C). Replace any washer that is damaged or deteriorated.
10. Tighten the bolts in two or three steps. In the final step tighten all bolts, in sequence, 12 Nm (1.2 kgf-m, 8.7 ft. lbs.).
11. Tighten the three bolts (A) securing the harness holder.
12. Install the breather hose (B) and ground cable (C).
13. Connect the three injector connectors, VTEC solenoid valve connector, and VTEC oil pressure switch connector to the rear cylinder head.
14. Install the three ignition coils from the rear cylinder head.
15. Install the intake manifold.
