Accord V6-3.0L Hybrid (2005)
10. Close the hook portion of the band with commercially available boot band pincers (A), then hook the tabs (B) of the band.
11. Install the boot band on the other end of the boot, and repeat steps 9 through 10.
12. Adjust the inboard joint until the rollers are in the middle of the joint.
13. Fit the boot ends onto the driveshaft and the inboard joint, then install the new double loop band (A) onto the boot.
14. Pull up the slack in the band by hand.
15. Mark a position (A) on the band 10 - 14 mm (0.4 - 0.6 inch) from the clip (B).