Accord V6-3.5L (2010)
4. Remove the front brake hose mounting bolt.
5. Remove the brake caliper lower flange bolt, then pivot the caliper up out of the way.
6. Remove the front brake pads, the shims, and the retainers.
7. Check the brake disc thickness.
Maximum refinishing limit:
26.0 mm (1.02 in)
8. If the disc is within the service limit for refinishing, refinish it with a Honda-approved, commercially available on-car brake lathe. If the disc is not
within the service limit, replace the disc.
9. Apply a thin coat of M-77 assembly paste to the retainer mating surface of the caliper bracket.
10. Install the pad retainers, then wipe off any excess assembly paste.
11. Mount the brake caliper piston compressor tool on the caliper body.
12. Press in the piston with the compressor tool so the caliper will fit over the brake pads. Make sure the piston boot is in position to prevent damaging
it when pivoting the caliper down.
