Accord V6-3.5L (2010)
14. Set the camshaft pulley to TDC before bolting them onto the engine block See: Service and Repair/Removal and Replacement/Cylinder Head
Installation (J35Z2 Engine).
Camshaft, Rocker Arm Assembly, Camshaft Seal, and Pulley Installation (J35Z3 Engine)
Camshaft, Rocker Arm Assembly, Camshaft Seal, and Pulley Installation
Front
1. Loosen the locknuts and the adjusting screws.
2. Clean and dry the camshaft oil seal housing.
3. Apply a light coat of new engine oil to the lip of the camshaft oil seal.
4. Gently tap the new camshaft oil seal (A) into the cylinder head.
1. Tap the camshaft oil seal in squarely.
2. Install the oil seal about 0.5-1.5 mm (0.02-0.06 in) below the surface of the cylinder head.
5. Insert the camshaft (B) into the cylinder head, then install the camshaft thrust cover (C). Always use a new O-ring (D). Apply new engine oil to the
