Accord V6-3.5L (2010)
Fuse Block: Service and Repair
Drivers Under-dash Fuse/Relay Box (Drivers MICU) Removal and Installation (Canada Models)
Driver's Under-dash Fuse/Relay Box (Driver's MICU) Removal and Installation
Special Tools Required
-
Relay Puller 07AAC-000A1A0 or 07AAC-000A2A1
Canada models
NOTE: SRS components are located in this area. Review the SRS component locations 4-door See: Restraint Systems/Air Bag Systems/Locations/SRS
Component Location Index (4-Door), 2-door See: Restraint Systems/Air Bag Systems/Locations/SRS Component Location Index (2-Door), and
precautions and procedures See: Air Bag(s) Arming and Disarming/Service and Repair before doing repairs or servicing.
Removal
1. Do the battery terminal disconnection procedure See: Starting and Charging/Battery/Service and Repair/Procedures.
2. Remove the driver's dashboard lower cover See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Removal and Replacement/Driver's Dashboard Lower Cover Removal/Installation, and the driver's kick panel:
-
4-door See: Body and Frame/Interior Moulding / Trim/Scuff Plate/Service and Repair/Interior Trim Removal/Installation - Door Areas
(4-Door)
-
2-door See: Body and Frame/Interior Moulding / Trim/Scuff Plate/Service and Repair/Interior Trim Removal/Installation - Door Areas
(2-Door)
3. Loosen the bolts (A), then remove the bolt (B) from the bracket (C).
4. Remove the bracket from the driver's under-dash fuse/relay box (D).
5. Disconnect the connectors from the fuse side of the driver's under-dash fuse/relay box (A).
