Accord V6-3.5L (2010)
Communications Control Module: Service and Repair
HandsFreeLink Control Unit Input Test/Replacement
1. Remove the driver's dashboard lower cover See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Removal and Replacement/Driver's Dashboard Lower Cover Removal/Installation.
2. Remove the screws, then disconnect the 28P connector (A) from the HandsFreeLink control unit (B).
3. Inspect the connector and socket terminals for a good pinfit to be sure they are all making good contact.
-
If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.
-
If the terminals look OK, go to step 4.
4. Reconnect the connector, and make these input tests at the connector.
-
If any test indicates a problem, find and correct the cause, then recheck the system.
-
If all the input tests prove OK, go to step 5.
5. Disconnect the 28P connector again, and make this input test at the connector.
-
If the test indicates a problem, find and correct the cause, then recheck the system.