honda Workshop Repair Guides

Honda Workshop Service and Repair Manuals

Instruments - Fuel Gauge Does Not Read Full|Page 11022 > < Instruments - Fuel Gauge Does Not Read Full|Page 11020
Page 1
background image

Fuel Gauge: Service and Repair

CAUTION:

-

All SRS wire harnesses are covered with yellow insulation. Before you disconnect any part of an SRS wire harness, connect the short
connectors.

-

Whenever the ignition switch is ON (II), or has been turned OFF for less than three minutes, be careful not to bump the SRS unit the airbags
could accidentally deploy and cause damage or injuries

-

Carefully inspect any SRS part before you install it Do not install any part that shows signs of being dropped or improperly handled, such as
dents, cracks or deformation:

- Airbag assemblies
- Cable reel
- SRS unit

-

Use only a, digital multimeter to check the system. If it's not a Honda multimeter, make sure its output is 10 mA (0.01 A) or less when
switched to the smallest value in the ohmmeter range. A tester with a higher output could damage the airbag circuit or cause accidental

Instruments - Fuel Gauge Does Not Read Full|Page 11022 > < Instruments - Fuel Gauge Does Not Read Full|Page 11020