Accord EX Coupe V6-3.0L (2001)
^
Push down and hold the window switch. Make sure the window goes all the way down.
^
Pull back and hold the window switch. Make sure the window goes all the way up, then hold the switch for at least 2 more seconds.
31.
Enter the anti-theft codes for the radio and navigation system (if equipped), and then enter your customer's radio presets.
32.
Reset the clock.
33.
Confirm that the steering wheel controls operate properly:
^
When you turn the ignition switch to ON (II), the SRS indicators come on for about 6 seconds and then go off.
^
Make sure the horn works properly.
^
Make sure the remote audio controls work properly.
^
Make sure the turn signals work properly.
REPAIR PROCEDURE B - ACCORD
NOTE:
Before doing any repairs or services, review the SRS components in this area (see page 23-24 of the 1998-02 Accord Service Manual) and the
precautions and procedures (see page 23-28).
1.
Make sure you have the anti-theft code for the radio. Write down your customer's radio station presets.
2.
Disconnect the battery negative cable. Wait at least 3 minutes to allow the SRS control unit to discharge.
3.
Remove the access panel from under the steering wheel.
4.
1998-00 models: Unplug the cable reel 2P connector from the driver's airbag 2P connector.
2001-02 models: Unplug the cable reel 4P connector from the driver's airbag 4P connector.