Accord EX Coupe V6-3.0L (2001)
NOTE: Sand the surface evenly, particularly at the area where the PP resin and mender meet.
8. Degreasing/Cleaning
-
Blow off the sanded surface, then clean with wax and grease remover.
WARNING:
-
Do not use high air pressure; use only an approved, 210 kPa (2.1 kgf/sq.cm,30 psi) air nozzle.
-
Wear goggles or safety glasses to prevent eye injury.
-
Remove all dust and dirt with a tack cloth.
9. Spraying dual-liquid bumper primer surfacer (gray)
NOTE: Use the urethane bumper primer.
WARNING:
-
Ventilate when spraying paint. Most paint contains substances that are harmful if inhaled or swallowed. Read the paint label before
opening the paint container.
-
Avoid contact with skin. Wear an approved respirator, gloves, eye protection, and appropriate clothing when painting.
-
Paint is flammable. Store it in a safe place, and keep it away from sparks, flames, or cigarettes.
Spray the primer surfacer over a wider area than the filler and the exposed surfaces of bumper primer.
NOTE: Spray 2-3 coats to get 20-25 microns of thickness.
Mixing Ratio: (Reference)
Urethane bumper primer 10
Hardener 1
Thinner 30-60%
10. Drying and polishing
Force dry the primer surfacer with infrared lamps or other industrial dryer.
WARNING: Body parts being dried with an industrial dryer can get hot enough to cause injury. Do not touch parts being dried.
Drying temperature:
Force drying 140 degrees F(60 degrees C) 20 minutes
Natural drying 68 degrees F(20 degrees C)2 hours min.
NOTE:
-
Use a dryer whenever possible.
-
Do not allow the temperature to exceed 158 degrees F (70 degrees C).
-1. After force drying, wet sand the primer surface with #600 sandpaper.
NOTE:
-
Use #600 or finer sandpaper as any paper coarser than this might scratch the surface.
-
Do not use high air pressure; use only an approved, 210 kPa (2.1 kgf/sq.cm, 30 psi) air nozzle
-
Wear goggles or safety glasses to prevent eye injury.
-2. Blow the surface to be repaired with compressed air then degrease with a wax and grease remover.
-3. Also clean and degrease where masking tape will be attached.
11. Intermediate coating
NOTE: Intermediate coating is recommended for bright colors.
-
Use the top coat enamel.
WARNING:
-
Ventilate when spraying paint. Most paint contains substances that are harmful if inhaled or swallowed. Read the paint label before
opening the paint container.
-
Avoid contact with skin. Wear an approved respirator, gloves, eye protection and appropriate clothing when painting.
-
Paint is flammable. Store it in a safe place, and keep it away from sparks, flames, or cigarettes.