Accord EX Coupe V6-3.0L (2001)
7. Check the brake disc for damage and cracks.
8. Install the pad retainers (A).
9. Apply Molykote M77 grease to both sides of the pad shims (A) and the back of the pads (B). Wipe excess grease off the shim.
10. Install the brake pads and pad shims correctly. Install the pad with the wear indicator (C) on the inside. If you are reusing the pads, always reinstall
the brake pads in their original positions to prevent loss of braking efficiency.
11. Push in the piston (A) so the caliper will fit over the pads. Make sure the piston boot is in position to prevent damaging it when pivoting the caliper
down.
NOTE: Check the brake fluid level, the brake fluid may overflow the reservoir if too full.
12. Pivot the caliper down into position, being careful not to damage the pin boot. Install the caliper bolt (B), and torque it to proper specification. If
the caliper pin head (C) is the hex. type, the caliper bolt should be installed by using a wrench while holding the caliper pin with another wrench.
Install the brake hose onto the knuckle.
13. Press the brake pedal several times to make sure the brakes work, then road-test.