Accord EX Coupe V6-3.0L (2001)
Remove, disassemble, inspect, reassemble, and install the caliper and note these items
-
Do not spill brake fluid on the vehicle; it may damage the paint; if brake fluid gets on the paint, wash it off immediately with water.
-
Clean all parts in brake fluid and air dry; blow out all passages with compressed air.
-
Before reassembling, check that all parts are free of dirt and other foreign particles.
-
Replace parts with new ones as specified in the illustration.
-
Make sure no dirt or other foreign matter gets into the brake fluid.
-
Make sure no grease or oil gets on the brake discs or pads. When reusing pads, always reinstall them in their original positions to prevent loss of
braking efficiency.
-
Do not reuse drained brake fluid.
-
Always use Honda DOT 3 Brake Fluid. Non-Honda brake fluid can cause corrosion and shorten the life of the system.
-
Coat the piston, piston seal groove, and caliper bore with clean brake fluid.
-
Replace all rubber parts with new ones.
-
After installing the caliper, check the brake hose and line for leaks, interference, and twisting.