Accord EX Coupe V6-3.0L (2001)
7. Remove the intake manifold.
8. Remove the cylinder head covers.
9. Remove the front upper cover (see step 2).
10. Set the No. 1 piston at TDC (see step 10).
11. Push on the intake mid rocker arm (A) for the No. 1 cylinder. The mid rocker arm should move independently of the primary rocker arm (B) and
secondary rocker arm (C).
^
If the intake mid rocker arm does not move, remove the mid, primary, and secondary intake rocker arms as an assembly, and check that the
pistons in the mid and primary rocker arms move smoothly. If any rocker arm needs replacing, replace the primary, mid and secondary rocker
arms as an assembly, and retest.
^
If the mid rocker arm moves freely, go to step 12.
12. Repeat step 11 on the remaining intake mid rocker arms with each piston at TDC. When all the mid rocker arms pass the test, go to step 13.
13. Check that the air pressure on the shop air compressor gauge indicates over 690 kPa (7.0 kgf/cm2, 100 psi).
14. Inspect the valve clearance.
15. Cover the timing belt with a shop towel to protect the belt.
16. Remove the 2 intake rocker shaft mounting bolts, then connect the special tools and Valve Inspection an air pressure regulator with a 0 - 100 psi
gauge (A) as shown.
17. Loosen the valve on the regulator and apply the specified air pressure.
Specified Air Pressure: 390 kPa (4.0 kgf/cm2, 57 psi)