Accord EX Coupe V6-3.0L (2001)
![background image](/honda/accord_ex_coupe/v6-3.0l/Page-521004.png)
19. Torque the bearing cap bolts (A), then torque the bearing cap side bolts (B). Follow the numbered sequence shown.
NOTE: Whenever any crankshaft or connecting rod bearing is replaced, it is necessary after reassembly to run the engine at idling speed until it
reaches normal operating temperature, then continue to run it for about 15 minutes.
20. The seal mating surface on the engine block end cover should be dry.
21. Drive the crankshaft oil seal squarely into the left side cover.