Accord EX Coupe V6-3.0L (2001)
Traction Control Indicator Lamp: Testing and Inspection
TCS INDICATOR CIRCUIT TROUBLESHOOTING
1. Start the engine, and watch the TCS indicator.
Does the TCS indicator come on?
YES - If the TCS indicator comes on and goes off, It's OK. If the TCS indicator stays on, go to step 7.
NO - Go to step 2.
2. Turn the engine OFF, then restart it again.
Does the brake system indicator come on?
YES - Go to step 3.
NO - Repair open in the indicator power source circuit.
-
Blown BACK UP LIGHT (7.5 A) fuse.
-
Open in the wire between the BACK UP LIGHT (7.5 A) fuse and the gauge assembly.
-
Open circuit inside the fuse box.
3. Turn the engine OFF, and check the TCS indicator bulb in the gauge assembly.
Is the bulb OK?
YES - Go to step 4.
NO - Replace the TCS indicator bulb.
4. Connect the gauge assembly connector B (22P) terminal B18 and body ground with a jumper wire. Turn the ignition switch ON (II).
Does the TCS indicator come on?
YES - Go to step 5.
NO - Replace the gauge assembly.
5. Remove the jumper wire at the gauge assembly, and connect the ABS/TCS control unit connector B (16P) terminal B16 and body ground with a
jumper wire.
Does the TCS indicator come on?
YES - Go to step 6.
NO - Repair open in the wire between the gauge assembly and the ABS/TCS control unit.
6. Connect the ABS/TCS control unit connector C (12P) terminal C2 and body ground with a jumper wire.