04-004 Aug 04 Engine Controls - MIL ON/DTC P0107or P0108 Set
![background image](/honda/accord_ex_coupe/v6-3.0l/Page-803010.png)
8.
Snap the retainer into place on the new 3P connector.
9.
Remove the MAP sensor and the 0-ring from the throttle body (two washer-screws). Discard the sensor and the 0-ring, but save the washer-screws.
10.
Position the new 0-ring on the throttle body. Then install the sensor spacer with the washer-screws you saved in step 9.
11.
Install the new MAP sensor on the sensor spacer (one washer-screw). Then plug the small (black) end of the adapter harness into the sensor.
12.
Install the adapter harness bracket on the throttle body (one flange bolt).