Accord EX Coupe V6-3.0L (2001)
REPAIR PROCEDURE - CIVIC (U.S.-BUILT)
NOTE:
Discard the instructions that came with the kit; they are incorrect for this repair. Follow this procedure instead.
1.
Remove the air cleaner.
2.
Release the engine harness from its clamp. Then unplug the 3P connector from the MAP sensor.
3.
Use a small, flat-tip screwdriver to pry out the retainer from the 3P connector. Also, pry out the retainer from the new 3P connector.
4.
Remove the No. 1 terminal (YEL/RED wire) from the old 3P connector.