Accord EX Coupe V6-3.0L (2001)
5.
Remove the intake manifold chamber, IAT sensor, boost plate, and PCV hose from the intake manifold.
6.
Cover the six ports on the bottom of the manifold with duct tape.
7.
Use an 8-mm drill bit and carburetor cleaner to clean the EGR port in the intake manifold. Turn the drill bit only by hand. Do not use a power
drill.
8.
Put the special drill bit from the EGR pipe installation kit in your power drill. Coat the drill bit completely with clean engine oil.
NOTE:
The oil coating is critical to drilling the hole accurately, and it contributes to drill bit life.