Accord EX Coupe V6-3.0L (2001)
6. Disconnect the 2P connector between the side airbag (A) and the side wire harness (B).
Seat belt tensioner:
7. Disconnect the 2P connector between the seat belt tensioner (A) and side wire harness (B).
8. Pull the seat belt out all the way and cut it.
9. Cut off each airbag connector, strip the ends of the wires, and connect the deployment tool alligator clips (A) to the wires. Place the deployment
tool at least 30 feet (10 meters) away from the vehicle.
NOTE: The driver's airbag and front passenger's airbag have four wires, two yellow (1st inflator) and 2 red (2nd inflator). Twist each pair of
unlike colored wires together, and connect an alligator clip to each pair.
10. Connect a 12 volt battery to the tool.
-
If the green light on the tool comes on, the igniter circuit is defective and cannot deploy the component. Go to Disposal of Damaged Airbag.
-
If the red light on the tool comes on, the component is ready to be deployed.