Accord EX Coupe V6-3.0L (2001)
1. Place the new driver's airbag (A) in the steering wheel, and secure it with new Torx bolts (B). Install the covers (C).
2. Connect the cable reel 2P (or 4P) connector (A) to the driver's airbag 2P (or 4P) connector (B), then install the access panel (C) on the steering
wheel.
3. Connect the battery negative cable.
4. After installing the airbag, confirm proper system operation:
-
Turn the ignition switch ON (II); the SRS indicator light should come on for about 6 seconds and then go off.
-
Make sure both horn buttons work.
Front Passenger's Airbag Replacement
Removal
1. Disconnect the battery negative cable, and wait at least 3 minutes before beginning work.