Accord EX Coupe V6-3.0L (2001)
2. Disconnect the side airbag harness 2P connector (A).
3. Remove the seat assembly, and seat-back cover.
4. Remove the two mounting nuts (A) and the side airbag (B).
Installation
NOTE: Be sure to install the harness wires so that they are not pinched or interfering with other parts.
NOTE:
-
If the side airbag lid is secured by a tape, remove the tape.
-
Do not open the lid of the side airbag cover.
-
Use new mounting nuts tightened to the specified torque when you replace a side airbag.
-
Make sure that the seat-back cover is installed properly. Improper installation may prevent proper deployment.
1. Place the new side airbag on the seat back-frame (A). Tighten the side airbag mounting nuts (B).
2. Install the new seat-back cover.
3. Install the seat assembly, then connect the side airbag harness 2P connector.
4. Move the front seat and the seat-back through their full ranges of movement, making sure the harness wires are not pinched or interfering with