Accord EX Coupe V6-3.0L (2001)
19. Measure the length of both brushes (A) with a vernier caliper (B).
-
If either brush is shorter than the service limit, replace the brush assembly.
-
If brush length is OK, go to step 20.
Alternator Brush Length:
Standard (New): 10.5 mm (0.41 in.)
Service Limit: 1.5 mm (0.06 in.)
Rotor Slip Ring test
20. Check that there is continuity between the slip rings (A).
-
If there is continuity, go to step 21.
-
If there is no continuity, replace the alternator.
21. Then check that there is no continuity between each slip ring (A) and the rotor (B) and the rotor shaft (C).
-
If there is no continuity, go to step 22.
-
If there is continuity, replace the alternator.
Stator Test
22. Check that there is continuity between each pair of leads (A).