honda Workshop Repair Guides

Honda Workshop Service and Repair Manuals

Power Steering Pump|Service and Repair > < Fluid Leakage Inspection|Page 5177
Page 2
background image

NOTICE:  Do not keep the pressure control valve closed more than 5 seconds or the pump could be damaged by over-heating.

11. Immediately open the pressure control valve fully. If the pump is in good condition, the gauge should read at least 7,600 - 8,300 kPa (78 - 85

kgf/cm2, 1,110 - 1,210 psi). A low reading means pump output is too low for full assist. Repair or replace the pump.

Power Steering Pump|Service and Repair > < Fluid Leakage Inspection|Page 5177