Accord LX Sedan L4-2156cc 2.2L SOHC MFI (1997)
Evaporator Core: Service and Repair
Removal and Installation
CAUTION:
-
All SRS wire harnesses are covered with yellow insulation. Before you disconnect any part of an SRS wire harness, disconnect the airbag
connectors.
-
Whenever the ignition switch ON (II), or has been turned OFF for less than three minutes, be careful not to bump the SRS unit; the airbags could
accidentally deploy and cause damage or injuries.
-
For additional precautions, refer to Air Bags and Seat Belts.
1. Recover the refrigerant with a Recovery/Recycling/Charging System.
2. Disconnect the receiver line and the suction line from the evaporator.
NOTE: Plug or cap the lines immediately after disconnecting to avoid moisture and dust contamination into the system.
