Accord LX Sedan L4-2156cc 2.2L SOHC MFI (1997)
11. Remove the two flange bolts, then remove the valve body unit from the gearbox.
12. Drill a 3 mm (0.12 inch) diameter hole approximately 2.5 - 3.0 mm (0.10 - 0.12 inch) in depth in the staked point on the cylinder.
CAUTION:
^
Do not allow metal shavings to enter the gearbox housing.
^
After removing the cylinder end, remove any burrs at the stake point.
13. Install special tool to the gearbox housing. Clamp the too in a vise with soft jaws as shown, then loosen and remove the cylinder end.
CAUTION: Do not clamp the cylinder.
14. Remove the steering gearbox housing from the vise, and set it the in a press so the gearbox points upward.