Accord LX Sedan L4-2156cc 2.2L SOHC MFI (1997)
Steering Wheel: Service and Repair
Removal
WARNING:
- All SRS wire harnesses are covered with yellow insulation. Before you disconnect any part of an SRS wire harness, disconnect the airbag
connectors.
- Whenever the ignition switch ON (II), or has been turned OFF for less than three minutes, be careful not to bump the SRS unit; the airbags
could accidentally deploy and cause damage or injuries.
REMOVAL
1. Disconnect the battery negative cable, then disconnect positive cable.
2. Remove the access panel from the steering wheel lower cover.
3. Disconnect the connector between the airbag and cable reel.
NOTE: Some SRS system connectors have a spring loaded lock. To release the lock, pull the spring-loaded sleeve toward the stop. Then pull the
connector halves apart. Be sure to pull on the sleeve and not on the connector half itself.