Accord LX Sedan L4-2254cc 2.3L SOHC (VTEC) MFI (1998)
8. Dispose of the complete airbag. No part of it can be reused. Place it in a sturdy plastic bag (A), and seal it securely.
Passenger's Air Bag
Special Tool Required
Deployment tool: ....................................................................................................................................................................................... 07HAZ-SG00500
Before scrapping any airbags (including those in a whole vehicle to be scrapped), the airbags must be deployed. If the vehicle is still within the warranty
period, before you deploy the airbags, the Honda District Service Manager must give approval and/or special instructions. Only after the airbags have
been deployed (as the result of vehicle collision, for example), can they be scrapped. If the airbags appear intact (not deployed), treat them with extreme
caution. Follow this procedure:
DEPLOYING AIRBAGS IN THE VEHICLE
If an SRS equipped vehicle is to be entirely scrapped, its airbags should be deployed while still in the vehicle. The airbags should not be considered as
salvageable parts and should never be installed in another vehicle.
1. Turn the ignition switch OFF, and disconnect the battery negative cable and wait at least three minutes.
2. Confirm that each airbag is securely mounted.
3. Confirm that the special tool is functioning properly by following the check procedure on the tool label.
4. Remove the glove box, then disconnect the 2P connector between the front passenger's airbag (A) and SRS main harness (B).