Accord LX Sedan L4-2254cc 2.3L SOHC (VTEC) MFI (1998)
4. Install the pinion shaft grommet (A). Align the slot (B) in the pinion shaft grommet with the lug portion on the valve housing.
5. Install the mounting cushion (A) on the steering gearbox.
6. Install the mounting brackets (B) over the mounting cushion, then install the two gearbox mounting bolts (C). Position the split portion (D) of the
mounting cushion.
7. Install the stiffener plates (E) with the two gearbox mounting bolts (F) and six stiffener plate attaching bolts (G). Install the bolts loosely first, then
tighten them securely.
8. Center the steering rack within its stroke.
9. Install the steering joint (A), and reconnect the steering shaft (B) and pinion shaft (C). Make sure the steering joint is connected as follows:
-
Insert the upper end of the steering joint onto the steering shaft (line up the bolt hole (D) with the flat portion (E) on the shaft).
-
Slip the lower end of the steering joint onto the pinion shaft (line up the bolt hole (F) with the groove around the shaft), and loosely install the
lower joint bolt. Be sure that the lower joint bolt is securely in the groove in the pinion shaft.
-
Pull on the steering joint to make sure that the steering joint is fully seated. Then install the upper joint bolt and tighten it.
10. Center the cable reel by first rotating it clockwise until it stops. Then rotate it counterclockwise (about 2 turns) until the arrow mark on the label
points straight up. Reinstall the steering wheel.