Accord SE Sedan L4-2254cc 2.3L SOHC (VTEC) MFI (2002)
27. Before installing the balancer driven gear (A) and the balancer gear case (B) apply molybdenum disulfide (C) to the thrust surfaces of the balancer
nears as shown.
28. Install the balancer driven gear.
^
1 Remove the bolt (A) and washer (B) from the maintenance hole (C).
^
2 Scribe a line on a 6 x 100 mm bolt, 74 mm from the end.
^
3 Insert the bolt in the maintenance hole and into the hole in the rear balancer shaft (D) up to the line you scribed.
^
4 Install the balancer driven gear (E).