Accord SE Sedan L4-2254cc 2.3L SOHC (VTEC) MFI (2002)
5. Disconnect the connector (A) from the evaporator temperature sensor, then remove the self-tapping screws, the mounting nut, the mounting bolts
and the evaporator (B).
6. Install the evaporator in the reverse order of removal, and note these items:
-
If you're installing a new evaporator, add refrigerant oil (DENSO ND-01L8).
-
Replace the O-rings with new ones at each fitting, and apply a thin coat of refrigerant oil before installing them. Be sure to use the right
O-rings for HFC-134a (R-134a) to avoid leakage.
-
Immediately after using the oil, replace the cap on the container, and seal it to avoid moisture absorption.
-
Do not spill the refrigerant oil on the vehicle; it may damage the paint; if the refrigerant oil contacts the paint, wash it off immediately.
-
Make sure that there is no air leakage. Charge the system.