honda Workshop Repair Guides

Honda Workshop Service and Repair Manuals

A/C Signal|Testing and Inspection|Page 2751 > < A/C Signal|Testing and Inspection
Page 2
background image

13. Disconnect ECM/PCM connector A (32P)

14. Check for continuity between body ground and ECM/PCM connector terminal A27.

Is there continuity?

YES - Repair short in the wire between the ECM/PCM (A27) and the A/C pressure switch. 

NO - Substitute a known-good ECM/PCM and recheck. If the prescribed voltage is now available, replace the original ECM/PCM. If not, check
the A/C system for other symptoms.

15. Momentarily connect under-hood fuse/relay box 16 P connector terminal No.11 to body ground with a jumper wire several times.

NOTE:  The under-hood fuse/relay box 16P connector is on the bottom of the fuse box. When you unbolt and invert the fuse box, leave the upper
cover on to prevent short circuits.

Is there a clicking noise from the A/C compressor clutch?

YES - Repair open in the wire between the ECM/PCM (A17) and the A/C clutch relay.

NO - Check the A/C system for other symptoms.

16. Measure voltage between ECM/PCM connector terminals A27 and B20.

Is there less than 1.0 V ?

A/C Signal|Testing and Inspection|Page 2751 > < A/C Signal|Testing and Inspection