Accord SE Sedan L4-2254cc 2.3L SOHC (VTEC) MFI (2002)
4. Remove the rear stiffener (A).
5. Disconnect the 2nd clutch pressure switch connector.
6. Replace the 2nd clutch pressure switch (A), then install a new one with a new sealing washer (B). Tighten the switch on the metal part, not the
plastic part.
7. Install the rear stiffener (A), then tighten the 10 x 1.25 mm bolt (B) to the specified torque.
8. Secure the nut (C) by your hand until it contacts the stiffener, then tighten it to the specified torque. If you can not tighten the nut to the stiffener
surface by hand, replace the nut and the special bolt (D).
9. Reconnect the connector, making sure there is no water, oil, dust, or other foreign particles inside it.