Accord SE Sedan L4-2254cc 2.3L SOHC (VTEC) MFI (2002)
_mfi/Page-1307002.png)
5. Bleed the clutch hydraulic system. Tighten the bleeder screw to 8 Nm (0.8 kgf-cm, 6 ft. lbs.).
NOTE: Be careful not to damage the slave cylinder by over tightening the bleeder screw.
-
Attach a hose to the bleeder screw (A), and suspend the hose in a container of brake fluid. Make sure there is an adequate supply of fluid at the
clutch master cylinder, then slowly pump the clutch pedal until no more bubbles appear at the bleeder hose. Refill the clutch master cylinder
with fluid when done.
-
Always use only Genuine Honda DOT 3 brake fluid.