honda Workshop Repair Guides

Honda Workshop Service and Repair Manuals

Instruments - Fuel Gauge Does Not Read Full|Page 11052 > < Instruments - Fuel Gauge Does Not Read Full|Page 11050
Page 2
background image

deployment and possible injury.

-

Do not install used SRS parts from another car. When making SRS repairs, use only new parts.

-

Except when performing electrical inspections, always disconnect both the negative cable and positive cable from the battery, and wait at least
three minutes before beginning work.

-

Replacement of the combination light and wiper/washer switches and cruise control switch can be done without removing the steering wheel:

-

Whenever the ignition switch is ON (II), or has been turned OFF for less than three minutes, be careful not to bump the SRS unit; the airbags
could accidentally deploy and cause damage or injuries.

-

Whenever the airbag has been activated, replace the SAS unit.

-

The original radio has a coded theft protection circuit. Be sure to get the customer's code number before disconnecting the battery cables.

1.  Remove the rear console.

2. Remove the front console panel.
3. Remove the stereo radio/cassette player.

4. Remove the switches from the instrument panel.

5. Remove the instrument panel.

If necessary, disconnect the air mix control cable from the heater unit.

 

Instruments - Fuel Gauge Does Not Read Full|Page 11052 > < Instruments - Fuel Gauge Does Not Read Full|Page 11050