Accord Wagon L4-2.2L SOHC VTEC (1996)
Ignition Lock: Service and Repair
CAUTION:
All SRS wire harnesses are covered with yellow insulation. Before you disconnect any part of an SRS wire harness, disconnect the airbag connectors.
Whenever the ignition switch ON (II), or has been turned OFF for less than three minutes, be careful not to bump the SRS unit; the airbags could
accidentally deploy and cause damage or injuries.
For additional precautions.
NOTE: The original radio has a coded theft protection circuit. Be sure to get the customer's code number before
-
disconnecting the battery.
-
removing the No.39 (7.5 A) fuse from the underhood fuse/relay box.
-
removing the radio.
After service, reconnect power to the radio and turn it on. When the word "CODE" is displayed, enter the customer's 5-digit code to restore radio
operation.
1. Disconnect the battery ground cable, then disconnect the starter (positive) cable.
2. Remove the dashboard lower cover and knee bolster.
3. Remove the steering column covers.