Accord Wagon L4-2.2L SOHC VTEC (1996)
Ball Joint: Service and Repair
Lower Ball Joint Replacement
1. Remove the knuckle, then remove the hub unit from the knuckle.
2. Remove the boot by prying the set ring off.
3. Check the boot for deterioration and damage, and replace it if necessary.
4. Remove the 40 mm circlip.
5. Install the special tools on the ball joint, and tighten the castle nut.
6. Position the special tools over the ball joint as shown, then set the assembly in a vise. Press the ball joint out of the knuckle.
7. Place the ball joint in position by hand.
8. Install the special tools over the ball joint as shown, then press the ball joint in.
9. Install the 40 mm circlip.
10. Install the ball joint boot and set ring using the special tool.
11. Install the hub unit onto the knuckle.
12. Install the knuckle.
13. Check the front wheel alignment, and adjust if necessary.
Ball Joint Boot Replacement